New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

1987 Rx-7 Flooding Issue. Newbie Help!

Thread Tools
 
Search this Thread
 
Old 06-21-19, 12:04 AM
  #1  
Can Post Only in New Member Section
Thread Starter
 
RyosukeProjectD's Avatar
 
Join Date: Jun 2019
Location: Chicago, IL
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
IL 1987 Rx-7 Flooding Issue. Newbie Help!

Hello, all I am a newbie to the Rx-7 forums and Rx-7's in general. This is my first post. I got my first 1987 Rx-7 about 3 months ago with about 56k original miles (according to the previous owner). This Rx-7 is a drift car. It has been stripped of all interior things and has a welded diff. It also has omp delete along with powering steering and perhaps some other things that I’m not too sure about. I’ve already been hit by the notorious flooding issue. The issue would occur when I would floor the car to redline. When I’d get close to redline the car would suddenly start breaking up and jerking. At this point, I realized the car was flooded. I then had to do the common unflooding procedure of taking out the specific fuse and cranking it a few times. The flooding while flooring went away after I changed my trailing and leading coils. However, the issue still persists when I try doing a clutch kick. Still learning how to drift, but sometimes I don’t even break traction and I just clutch kick but end up flooring the car in first gear. Immediately after those series of things the car experiences the same symptoms as before and floods. I then have to unflood the car to get it to driving properly again. I have read through previous forums on bandaid fixes and probable causes, but I just can't seem to figure it out.

Any help would be appreciated. Thanks for taking the time to read.




Things I’ve already done to try fixing the flooding issue:
  • Took out the fuel injectors. Did a thorough clean by running carb cleaner through it and seeing the injectors spraying properly.
  • Changed both leading and trailing coils.
  • Changed spark plugs & oil change.
  • Compression test. Everything checked out okay.
Old 06-21-19, 09:45 AM
  #2  
Junior Member
 
Shoal07's Avatar
 
Join Date: Nov 2016
Location: Fairfax Station, VA
Posts: 27
Likes: 0
Received 0 Likes on 0 Posts
I know the guys that race these tend to ditch the fuel injection system entirely and go carborated. Better power and more reliable. The one thing I can think of is a fuel pressure problem, e.g., too much. Does it have a fuel pressure adjustment (my first gen does)? Sounds like as you're increasing in power it's flowing too much fuel, and maybe something needs to be backed off a little (without going lean).
Old 06-21-19, 04:32 PM
  #3  
Can Post Only in New Member Section
Thread Starter
 
RyosukeProjectD's Avatar
 
Join Date: Jun 2019
Location: Chicago, IL
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by Shoal07
I know the guys that race these tend to ditch the fuel injection system entirely and go carborated. Better power and more reliable. The one thing I can think of is a fuel pressure problem, e.g., too much. Does it have a fuel pressure adjustment (my first gen does)? Sounds like as you're increasing in power it's flowing too much fuel, and maybe something needs to be backed off a little (without going lean).
Yes, sorry forgot to mention fpr in the list of things I already tried. I borrowed a cousin's aftermarket Tomei fpr. Installed the actual fpr and gauge. Set it to the correct spec. However, I get the same result when attempting to drift.
Old 06-21-19, 04:36 PM
  #4  
Moderator

iTrader: (3)
 
diabolical1's Avatar
 
Join Date: Feb 2002
Location: FL
Posts: 10,822
Received 307 Likes on 268 Posts
welcome to the board.

1. what plugs are you running?

2. what do you have for exhaust?
The following users liked this post:
Rx7K20 (07-18-19)
Old 06-22-19, 11:38 AM
  #5  
Can Post Only in New Member Section
Thread Starter
 
RyosukeProjectD's Avatar
 
Join Date: Jun 2019
Location: Chicago, IL
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by diabolical1
welcome to the board.

1. what plugs are you running?

2. what do you have for exhaust?
Hey, thanks! Glad to be apart of the community! I recently bought and installed NGK BUR7EQ and BUR9EQ spark plugs. I also bought a new spark plug wire set. As for my exhaust, I didn't do anything to it except add a resonator in hopes to quiet it down. Unfortunately, the addition of the resonator made a pinch of a difference. Still very loud. The car just has a straight pipe with the outer diameter of the exhaust tip being 4 1/2 inches.
Old 06-22-19, 04:14 PM
  #6  
Moderator

iTrader: (3)
 
diabolical1's Avatar
 
Join Date: Feb 2002
Location: FL
Posts: 10,822
Received 307 Likes on 268 Posts
i will take it that your ignition system is functioning the way it should since you mentioned changing coils, so the following is based on that assumption.

well, if you're game, you can try the NGK B_ES plugs (keep the stock heat ranges for lead and trail) and see if they improve your situation any. i started experimenting with plugs a while back when i was having flooding issues and i used the B_EV plugs, but apparently they have been discontinued now, so these seem to be the same plug with a different material for the electrode. the actual replacement for the ones i used to use are the BR_EIX plugs, but i'm not sure what your budget is and i can't guarantee that the plugs will solve/help YOUR problems so i figure start with the cheaper versions and if it helps, then you can get the iridiums later on if you want.

also, see if you can get a timing light and see where you are, too.
Old 06-23-19, 12:23 AM
  #7  
Can Post Only in New Member Section
Thread Starter
 
RyosukeProjectD's Avatar
 
Join Date: Jun 2019
Location: Chicago, IL
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Yes, my ignition system I believe is fine. I will take these other spark plugs into account next time I change the plugs. Any other possibilities or things I can try?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Sammy Built
3rd Generation Specific (1993-2002)
7
12-16-14 01:45 PM
t-von
Rotary Car Performance
5
10-11-06 02:49 PM
scamp83
2nd Generation Specific (1986-1992)
6
02-26-06 05:17 PM
CHPFLNG
2nd Generation Specific (1986-1992)
7
09-07-01 04:51 AM



Quick Reply: 1987 Rx-7 Flooding Issue. Newbie Help!



All times are GMT -5. The time now is 05:49 AM.