1985 rx7
Thread Starter
Can Post Only in New Member Section
Joined: Oct 2011
Posts: 3
Likes: 0
From: waverly, NY
Hi everyone. My name is alan and i just got a 1985 rx7. i have a question tho i was told the seals are going and it smokes when i start it and while running so i just have it parked in my driveway i was wondering what seals do i need to replace to stop this it smells like its burning antifreeze if that helps.
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
If you are burning coolant, then the "seals" involved are the coolant o-rings that seal between the irons and housings. These seals wear out, crack, or the iron itself corrodes/cracks.
Unfortunately, the only way to replace these seals is to disassemble and rebuild the engine.
Unfortunately, the only way to replace these seals is to disassemble and rebuild the engine.
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
An entire engine gasket set, plus a set of apex, side, corner, oil seals. Plus depending on the age of the engine, you may also need main and rotor bearings.
Best to verify that you are actually burning coolant via a cooling system pressure test or the bubble test before you tear the engine down.
Best to verify that you are actually burning coolant via a cooling system pressure test or the bubble test before you tear the engine down.
Thread
Thread Starter
Forum
Replies
Last Post
dludden
1st Generation Specific (1979-1985)
1
Aug 26, 2015 11:25 AM




