hi im new to the rx7 club. i know this may sound stupid but , well i bought my 7 a month ago and i couldnt figure out why it wouldnt want to idle when cold , so i started reading up on what the problem could be, and most people said it was the B.A.C so i went and i looked at mine and to my surprise the connector for the B.A.C was cut and just ducked taped ( unno why he did this ?) do i went out and bought a new connector but i do not know which wire goes to which side of the connector, any help would be great

 

It actually doesn't matter. The valve is non-polar.

 

thanks for the help .

 

Where did you buy the BAC connector????

 

used parts cars or you can use the older denso injector clips found aftermarket and shave off the locating lug on the BAC. same can be done with the water thermosensor.

 

Thanks!!