First post on here and it's gonna be a big one. My first car build, i built the whole thing. 13B-rew, S6 engine from Japan. Stock turbos with full non-sequential. MS3X ECU, Fi-tech 255 inline pump, LS3 coils, throttle body has been simplified to the bare minimum. No AC, no power steering, no air pump, nothing of a stock rx7 body at all except engine and trans. Question here is (yes ive read Aarons write up numerous times, I'm still green with tuning). With 4 individual coil packs, what do i need to change in the MS settings to run these? With the FF trigger kit (hal effect), do i need to enter that type of sensor somewhere? And what changes do i honestly need to make to Aarons write up to make this car drive out of my garage, down the driveway, and back as quick as possible. Everything is wired up except the starter and TPS which will be done tomorrow. Any and all suggestions will be helpful and I'll answer any questions to help with getting this thing started.