[RX7 FD] Front Light Problem.
#1
[RX7 FD] Front Light Problem.
I explain my problem.
It started a few weeks ago, my right front light began to decrease in intensity. Every day it got worse ..
The problem today is that there really is no more scope and I can not have you just found the problem.
When I turn on the lights, the LED lights slightly enlightened road then they are not running.
I think I have a slight short circuit somewhere, but I really do not know where to start ..
I changed the bulb in the first place.
I attached some pictures, you will see the difference.
Thanks !
It started a few weeks ago, my right front light began to decrease in intensity. Every day it got worse ..
The problem today is that there really is no more scope and I can not have you just found the problem.
When I turn on the lights, the LED lights slightly enlightened road then they are not running.
I think I have a slight short circuit somewhere, but I really do not know where to start ..
I changed the bulb in the first place.
I attached some pictures, you will see the difference.
Thanks !
#5
always something to fix
iTrader: (30)
Join Date: Nov 2011
Location: South East MI
Posts: 518
Likes: 0
Received 0 Likes
on
0 Posts
You might have to unwrap the electrical tape that's on the wire leading to the bulb. And check the connection.
I had the same problem, a temporary solution was to adjust the screws on the headlight housing around the corners and tighten them, to give slack for the connection from the car wire to the light bulb, but its better to just trace the wire and fix it
I had the same problem, a temporary solution was to adjust the screws on the headlight housing around the corners and tighten them, to give slack for the connection from the car wire to the light bulb, but its better to just trace the wire and fix it
#6
Thank you very much
Yesterday I again verified the connection of the bulb. One of the pods was slightly melted. By moving the bulb alone, I noticed that it was working normally again.
So I twisted the bulb lug it to have a proper based on connections. Over problem.
Electrical problem solved
Yesterday I again verified the connection of the bulb. One of the pods was slightly melted. By moving the bulb alone, I noticed that it was working normally again.
So I twisted the bulb lug it to have a proper based on connections. Over problem.
Electrical problem solved
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
rkhanso
2nd Generation Specific (1986-1992)
1
08-13-15 11:40 AM