Budds Creek MIR 7 Hang!
08-30-05, 02:17 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Budds Creek MIR 7 Hang!
Any Virginians or Marylanders wanna meet up on either Sunday Sept. 4th or the 5th for a Test and Tune session? $30 gets you in and on the track for as many runs as you want. I went to Midnight Madness last Friday and will NEVER go to that again. 3+ hours with only 2 runs. Sept. 4th is sponsored by the Quartermasters race group, they have some pretty fast American muscle but if we get there early, we'd have the track mosty to ourselves for a little while. Mon. has no sponsored event so it's open racing all day. Hope to see some of you guys down there! Brian
08-30-05, 04:30 PM
#3
Being Pis-TON
Join Date: Jun 2005
Location: VA
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Brian, put some 100 octane in there and launch that bad boy at 7000 - 8000 rpms and hold the **** on jack. Dave told me you were being to shy with the throttle or as Dave says "Dont be a *****!"
08-30-05, 04:43 PM
#4
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by CYM_T-61
Brian, put some 100 octane in there and launch that bad boy at 7000 - 8000 rpms and hold the **** on jack. Dave told me you were being to shy with the throttle or as Dave says "Dont be a *****!"
I put 110 in that bad boy and ran slower. Talked to Ray today and found out why, so I got some good pointers and should be ready by this weekend. If I break an axle you gotta help me replace it!
Did you get a 3rd gen. yet?
Last edited by BMac; 08-30-05 at 04:49 PM.
08-30-05, 04:53 PM
#6
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Yeah man, thanks for letting me borrow them. I didn't really use them to their potential so I'd like to try this weekend since I still have some 110 octane in the tank. I'm gonna mix it with 93, my map wasn't setup to handle that high octane. Shoulda put the 104 in and leaned it out 5%. Maybe Mon. would be better.
Trending Topics
08-30-05, 09:46 PM
#9
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
HAHA! Yeah after my first run I could expect that. Ray said I actually lost power because of the 110. I think I know what I have to do next time. Dave, I know you'd be the first one to help me fix my back end if it breaks! I tried your cell, but there was some other message on there.
Hey Jon, can you make it down to run your car too?
Hey Jon, can you make it down to run your car too?
Last edited by BMac; 08-30-05 at 09:50 PM.
08-30-05, 10:03 PM
#10
Sorry It's a new cell from work and I have not changed the message yet. Of coarse I would help work on your car just need notice.
Jon's car gets break up or something from the money metal purple box he is using I believe. So no racing till he gets AEM or something better than he has now from what I understand. Beer drinking is allowed though..
Oh yea I think I smell something.
Jon's car gets break up or something from the money metal purple box he is using I believe. So no racing till he gets AEM or something better than he has now from what I understand. Beer drinking is allowed though..
Oh yea I think I smell something.
08-31-05, 06:08 AM
#11
Banned. I got OWNED!!!
Join Date: Jul 2002
Location: DC
Posts: 1,035
Likes: 0
Received 0 Likes
on
0 Posts
Monday would be better for me.
Do you know what time the runs would
start on Monday??
I just bought a E39 M5 and want to time it.
And I need to adjust my boost controller on my FD.
Do you know what time the runs would
start on Monday??
I just bought a E39 M5 and want to time it.
And I need to adjust my boost controller on my FD.
08-31-05, 06:12 AM
#12
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Gates open at 10am. I might try to get there right at 10 so I'd have a lot of track time right off the bat. I guess I could start drinking beer right after I have some coffee!
Last edited by BMac; 08-31-05 at 06:15 AM.
08-31-05, 08:30 AM
#14
Do It! Do It!
Join Date: Mar 2004
Location: Crofton, MD
Posts: 1,994
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Fd3BOOST
Sorry It's a new cell from work and I have not changed the message yet. Of coarse I would help work on your car just need notice.
Jon's car gets break up or something from the money metal purple box he is using I believe. So no racing till he gets AEM or something better than he has now from what I understand. Beer drinking is allowed though..
Oh yea I think I smell something.
Jon's car gets break up or something from the money metal purple box he is using I believe. So no racing till he gets AEM or something better than he has now from what I understand. Beer drinking is allowed though..
Oh yea I think I smell something.
Beer drinking is always allowed, I may bring the FD down but not race.
08-31-05, 08:31 AM
#15
Do It! Do It!
Join Date: Mar 2004
Location: Crofton, MD
Posts: 1,994
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BMac
Gates open at 10am. I might try to get there right at 10 so I'd have a lot of track time right off the bat. I guess I could start drinking beer right after I have some coffee!
08-31-05, 10:49 AM
#16
Back in the 7 life again
urg, my car is sooo close to being finished but I doubt it will be done in time :-( We might drive down in the money saturn though.. run it for ***** and giggles.
08-31-05, 03:47 PM
#17
Brian, Trust me you are better off getting to the gates about 20-30min early if you really want to get in some quick passes. The lanes fill up fast.
Jon, Yea I am most likely going to go. I have not been drinking at 10am on a Monday morning since highschool.
Jon, Yea I am most likely going to go. I have not been drinking at 10am on a Monday morning since highschool.
08-31-05, 03:57 PM
#18
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
[QUOTE=Fd3BOOST]Brian, Trust me you are better off getting to the gates about 20-30min early if you really want to get in some quick passes. The lanes fill up fast.
Guess I was hoping there won't be too many people on labor day since they'd be on a trip somewhere. I'll get there earlier to make sure I get enough runs.
Where are all the other Marylanders that talk big 11's and 12's??? I wanna see some other 7's show me how it's done!
Guess I was hoping there won't be too many people on labor day since they'd be on a trip somewhere. I'll get there earlier to make sure I get enough runs.
Where are all the other Marylanders that talk big 11's and 12's??? I wanna see some other 7's show me how it's done!
08-31-05, 09:07 PM
#21
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Row-Tar-Eeeh
Damn you all! I can't make it on monday, but Sunday would be VERY doable! And I guess I met you this past Saturday Brian?
I don't start many threads and of course mine's gotta get jacked by some crap ad! WTF!?!?!?!
09-01-05, 05:53 AM
#22
[QUOTE=BMac]
Your assuming all the rednecks in Chuck County have something to do other than drink beer and race cars. Trust me there will be people there.
As far as rotaries down here in Southern Maryland. We are it. The other few Maryland guys all go to either 75/80 or Cecil county. I don't know of any rotaries other than maybe Jon or Sean who race at Capitol.
Originally Posted by Fd3BOOST
Brian, Trust me you are better off getting to the gates about 20-30min early if you really want to get in some quick passes. The lanes fill up fast.
Guess I was hoping there won't be too many people on labor day since they'd be on a trip somewhere. I'll get there earlier to make sure I get enough runs.
Where are all the other Marylanders that talk big 11's and 12's??? I wanna see some other 7's show me how it's done!
Guess I was hoping there won't be too many people on labor day since they'd be on a trip somewhere. I'll get there earlier to make sure I get enough runs.
Where are all the other Marylanders that talk big 11's and 12's??? I wanna see some other 7's show me how it's done!
Your assuming all the rednecks in Chuck County have something to do other than drink beer and race cars.
Trust me there will be people there. As far as rotaries down here in Southern Maryland. We are it. The other few Maryland guys all go to either 75/80 or Cecil county. I don't know of any rotaries other than maybe Jon or Sean who race at Capitol.
09-01-05, 07:46 AM
#23
Rotary Enthusiast
Join Date: Jun 2002
Location: abingdon, maryland
Posts: 1,447
Likes: 0
Received 0 Likes
on
0 Posts
what about me whenever i go i never see any 7s. well that's not true i use to see tonytt ? down there also. i get my car next week and i will probably head back down to capitol. kevin
whenever i go i never see any 7s. well that's not true i use to see tonytt ? down there also. i get my car next week and i will probably head back down to capitol. kevin
09-01-05, 08:39 AM
#24
Back in the 7 life again
kevin, do you have a ported motor or are you on stock ports? If you are on stockers I would like to do a heads up one day at the track (once my car is done of course).
09-01-05, 09:35 AM
#25
Senior Member
Thread Starter
Join Date: Mar 2001
Location: Waldorf, MD
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by fd3virgin
what about me whenever i go i never see any 7s. well that's not true i use to see tonytt ? down there also. i get my car next week and i will probably head back down to capitol. kevin
whenever i go i never see any 7s. well that's not true i use to see tonytt ? down there also. i get my car next week and i will probably head back down to capitol. kevinHey Neil, bring your car down anyway, I'd like to see what you had done since Nopi.