That or know any tricks to stop the motor from spinning while putting on the flywhell outside of the car. If you have one I can pay shipping.

 

.

 

the one I use costs less that $5 and you can get it at home depot.

Its a piece of steel that has pre drilled holes in it. You can buy it at any length. It is only about 1.5 inches wide and has holes about every 1 inch apart.

I enlongate one hole, I put a 14mm bolt through that one and bolt it to the normal holes that hold the tranny in place. I then put the other hole around a dowel pin.

That straps it in place and you can get to work from there.

Anthony[/QUOTE]

 

Ok cool thanks I just didnt wanna shel out the 50+$ for a new one I may only use once or twice. Well at least right now.

 

Were in VA are you at?

I can come over and have you use my trusty 3/4 electric impact gun