ok guys look im kinda stumped where is there a good 12v switched source wire located ? does anyone have a pic on their wiring like where did u run them to and the distributor coil where is the power coming from? where is this signal wire coming from ? im about to toss gas and flick a zippo im at that point everything else i can figure out but i am not sure how to run this at all do they run off the main fuse wire closer to the tower? or from the one on the opposite side of the wire from the tower? or should i run a 8gauge wire to the ignition under the dash? i have no effing clue what to do btw who has a oil cooler and hoses for sale any rx carb dudes in md i need some assistance here

 

you don't have a voltmeter? test light?

since you unplug at least one of the coil packs, i'd use its power wire, which is black with a yellow stripe.

and for the other coil pack i'd use (surprise) the other coil pack power wire.

in a distributor setup, YOU run the signal wire to the coil. the diagram is in every 81-85 shop manual which is @ www.foxed.ca

seriously though if you can't even do basic stuff like find a power wire, then this might not be for you

 

I do agree. Lol

 

ok from the coils, do each of them get a signal wire ? or just one to one coil ignitor? what colour is that wire btw

 

what about a ground ?