Holley/Racing Beat/2nd gen nstall help ?
#1
Holley/Racing Beat/2nd gen nstall help ?
I have been piecing together components to run a RacingBeat/Holley intake on my '86 6port. I have a Carter & a wallbro fuel pump,fpr,2-Blaster 2 coils,a 1st gen distributer & determination/almost broke status! Lol ! I have talked to RB,mazdatrix olde school- shade tree Rotor heads about detailed install Instructions on installing this setup but RB & Mazdatrix did not know? ("the system comes w/instructions")Fast Freddy's told me they would give me a diagram to use my stock coils/igniters IF.... I bought a new carb.(Which is understandable) I was hopeing one of my Bros from the club can map me out! IE:WIREING/installing the distributer & coils (which ones,stock or blasters!)!!
Thanx Yo!
Thanx Yo!
#3
come get some.....
iTrader: (2)
Join Date: Dec 2006
Location: bayamon pr, orlando fl, paterson nj
Posts: 1,763
Likes: 0
Received 0 Likes
on
0 Posts
very easy fix ............go to pick and pull cut of the oe wiring from a first gen, t"hat means the ones that go to the dist and coils " all the way into the firewall allmost . find a lead on your car that starts with the ign in the on position and your done . you can cut the other wiring or just tape them up . good luck
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
10-02-15 06:22 PM