so i tried to search for this and no results...is it possible to wire a wide band into the stock O2 sensor wire so that the AFR's will be accurate? i may not have explained this very well but i can't get an accurate readout for the AFR's it doesn't match what the wideband says.

please let me know if anyone has tried this

-ColdSeven

 

Need to know what WB you have, Just alil more info.

Short answer is this is possible on some wb's.. ex.My innovate will allow for this.

 

Not possible without a box to convert it to a narrrow band signal. I think the LC-1 does this.

 

ok well here's what i have...microtech LT10s

i don't have a WB yet that's why i want to know what the deal is with this so i can get the one i would need....

on top of this i got a new problem, for some reason my temp guage is reading "-0C" and the top rad hose was sucked flat no cooliant cycling through it at all.

i know this^^^is the wrong section but im stumped and need some wisdom, please help if possible

-ColdSeven

 

Massive airlock in the system?

 

^^^well update...both the caps were **** so i replaced them. haven't figured out why i can't get a reading on the Microtech JDM motor not sure if that has anyting to do with it.

any ideas? and no not airlock either

 

well figured out a few things about the current problem it was a loose connector to the neck on the water pump, feel a lil stupid about that one and one of the wires in the harness for the MT was not soldered together so it worked loose, i then went through and fixed it all there may still be some wires that need to be soldered so i will go through this week and check them all. not happy about this one but oh well.