wide band
so i tried to search for this and no results...is it possible to wire a wide band into the stock O2 sensor wire so that the AFR's will be accurate? i may not have explained this very well but i can't get an accurate readout for the AFR's it doesn't match what the wideband says.
please let me know if anyone has tried this -ColdSeven |
Need to know what WB you have, Just alil more info.
Short answer is this is possible on some wb's.. ex.My innovate will allow for this. |
Not possible without a box to convert it to a narrrow band signal. I think the LC-1 does this.
|
ok well here's what i have...microtech LT10s
i don't have a WB yet that's why i want to know what the deal is with this so i can get the one i would need.... on top of this i got a new problem, for some reason my temp guage is reading "-0C" and the top rad hose was sucked flat no cooliant cycling through it at all. i know this^^^is the wrong section but im stumped and need some wisdom, please help if possible -ColdSeven |
Massive airlock in the system?
|
^^^well update...both the caps were shit so i replaced them. haven't figured out why i can't get a reading on the Microtech JDM motor not sure if that has anyting to do with it.
any ideas? and no not airlock either |
well figured out a few things about the current problem it was a loose connector to the neck on the water pump, feel a lil stupid about that one and one of the wires in the harness for the MT was not soldered together so it worked loose, i then went through and fixed it all there may still be some wires that need to be soldered so i will go through this week and check them all. not happy about this one but oh well.
|
All times are GMT -5. The time now is 07:38 AM. |
© 2024 MH Sub I, LLC dba Internet Brands