Microtech WAT error
05-15-12, 09:46 PM
#1
1.3L piston eater
Thread Starter
WAT error
Microtechs troubleshooting guide is not available anymore dammit
What does the WAT error stand for? I recall long ago reading it could be the water temp sensor.. I just went over all the wiring for it and its fine, could the sensor be gone? The temp still reads on the DASH unit which is odd.. hence why im not sure if its the Water temp sens.
Ive been having a intermittent problem (horrendously rich idleing / stalls and dies / floods so bad needs to be push started) Last time it stalled on me / flooded after cranking and no go on the start i got WAT/REF/RPM Errors.
HELP!!
What does the WAT error stand for? I recall long ago reading it could be the water temp sensor.. I just went over all the wiring for it and its fine, could the sensor be gone? The temp still reads on the DASH unit which is odd.. hence why im not sure if its the Water temp sens.
Ive been having a intermittent problem (horrendously rich idleing / stalls and dies / floods so bad needs to be push started) Last time it stalled on me / flooded after cranking and no go on the start i got WAT/REF/RPM Errors.
HELP!!
05-16-12, 09:39 PM
#2
talking head
coolant temp went over 100 C ( off scale ) or maybe under scale cold ,, ,,hold down mode button for 3 secs to reset
most of the time the coolant sensor plastic top will be loose/ seperated and likely you have intermitant connection
most of the time the coolant sensor plastic top will be loose/ seperated and likely you have intermitant connection
Thread
Thread Starter
Forum
Replies
Last Post
scissorhands
New Member RX-7 Technical
0
09-16-15 01:25 PM
