Microtech Rev limiter on ltx-12
Thread Starter
Senior Member
Joined: Nov 2006
Posts: 475
Likes: 1
From: Oslo, Norway
Rev limiter on ltx-12
Hello
Just wonder what config on the ltx-12 you guys uses for rev limiting yopur rotary engine.
The only option i can find is to cut fuel, but this isn't good for the rotary engine so this is not an option for me, the second i know about is to feed the engine with way to much fuel when you get it to the revs you want it to do..(this is what I do now)
is there any other options to use with the ltx-12?
Roar Harlem
Norway
Just wonder what config on the ltx-12 you guys uses for rev limiting yopur rotary engine.
The only option i can find is to cut fuel, but this isn't good for the rotary engine so this is not an option for me, the second i know about is to feed the engine with way to much fuel when you get it to the revs you want it to do..(this is what I do now)
is there any other options to use with the ltx-12?
Roar Harlem
Norway
On a microtech.
their is revlim which cuts out one bank of injectors.
THIS IS BAD.
The rev cut, cuts out all injectors. This is a much safer cut as it shouldnt create a lean spot.
BUT if your on the rev cut alot, it can damage the engine.
Normally if i have tuned a car, i set the rev cut 1000rpm over the working powerband. This means it only cuts in the most extreme case rather then it cutting it all the time.
their is revlim which cuts out one bank of injectors.
THIS IS BAD.
The rev cut, cuts out all injectors. This is a much safer cut as it shouldnt create a lean spot.
BUT if your on the rev cut alot, it can damage the engine.
Normally if i have tuned a car, i set the rev cut 1000rpm over the working powerband. This means it only cuts in the most extreme case rather then it cutting it all the time.
Thread
Thread Starter
Forum
Replies
Last Post
Prediict
2nd Generation Specific (1986-1992)
32
Nov 18, 2015 08:41 AM
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM
