Microtech MT8 any good???
#1
Full Member
Thread Starter
Join Date: Aug 2003
Location: Sydney, Australia
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
MT8 any good???
For people fimiliar with the MT8...
I currently have a MT8 ecu but isn't setup yet, so I'm still using the stock ecu.
Just wondering if this is a good aftermarket ecu??. I got ripped off hard for this ecu from this fucked up mech(long story) and I regret buying it. Will this ecu support my future mods?? fmic, upgraded twins or even single, upgraded fuel system, high flow cat etc.... What are it's limitations (what **** about it!?!?).
I really like to get an Apexi PFC but since I have the MT8 just lying around I might as well use it.
Thanks,
Joseph
I currently have a MT8 ecu but isn't setup yet, so I'm still using the stock ecu.
Just wondering if this is a good aftermarket ecu??. I got ripped off hard for this ecu from this fucked up mech(long story) and I regret buying it. Will this ecu support my future mods?? fmic, upgraded twins or even single, upgraded fuel system, high flow cat etc.... What are it's limitations (what **** about it!?!?).
I really like to get an Apexi PFC but since I have the MT8 just lying around I might as well use it.
Thanks,
Joseph
#2
Senior Member
iTrader: (2)
Join Date: Oct 2003
Location: Pensacola, FL
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
The MT8 is a capable ECU and should support whatever you want to do in the future. However you may want to send it in and have it updated to the LT8 standard so you can use a laptop and gain the 3d fueling of the LT8.
Thread
Thread Starter
Forum
Replies
Last Post
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM