Microtech microtech 2 bar stock map sensor
#1
microtech 2 bar stock map sensor
After looking at the software for the first time last night, it was a 3 bar setup that had data point up to 28 psi. With the stock 2 bar sensor in the microtech, what does it go up to? 15 roughly? If so, whats it peak psi range, not the 28 psi hopefully.
Tim
Tim
#4
Tim.
The standard ecu & the 3 bar have the same number of load points but on thye 3 bar version the vacuum side points are spaced further apart to allow for a few more in the 20-30psi range.
Jon
The standard ecu & the 3 bar have the same number of load points but on thye 3 bar version the vacuum side points are spaced further apart to allow for a few more in the 20-30psi range.
Jon
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
08-22-15 05:52 PM