Microtech LT 8 questions
#1
Junior Member
Thread Starter
Join Date: Jan 2004
Location: RENO
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
LT 8 questions
I just ordered a lt8. Will the vehicle run on the stock map installed in the unit?
I dont have access to a dyno locally so will programing/tuning be a nightmare?
note:I am very new to rotarys, this motor and lt8 will be going in a buggy with 3" exhaust and k&n aircleaner.
I dont have access to a dyno locally so will programing/tuning be a nightmare?
note:I am very new to rotarys, this motor and lt8 will be going in a buggy with 3" exhaust and k&n aircleaner.
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
1. Yes, it should start and run with the stock maps. They are quite rich, so you'll need to pull out some fuel to get a decent idle.
2. If you have a wideband and can find a big hill without any traffic, you and a passenger could probably do an acceptable job at tuning. But there is no substitute for a dyno.
2. If you have a wideband and can find a big hill without any traffic, you and a passenger could probably do an acceptable job at tuning. But there is no substitute for a dyno.
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM