Microtech injectors hooked up wrong?
#1
Junior Member
Thread Starter
Join Date: Apr 2003
Location: australia
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
injectors hooked up wrong?
hi guys,
i think i may have had my injectors plugs swapped around..not primary and secondary but primary for rotor 1 swapped for primary on rotor 2...and possibly the secondaries where swapped around as well???????????
would this cause any probs????? are primary injectors fired at different timmings to each other
i think i may have had my injectors plugs swapped around..not primary and secondary but primary for rotor 1 swapped for primary on rotor 2...and possibly the secondaries where swapped around as well???????????
would this cause any probs????? are primary injectors fired at different timmings to each other
#2
Rick James
Join Date: Sep 2002
Location: Under The Hood In FL
Posts: 631
Likes: 0
Received 0 Likes
on
0 Posts
Yes, it will make for all kinds of probs. In lower rpms, the car is only using the primarys. If your shootting the pir. through the mani, when they should be in the block....not good. As far as on the #1 rotor, when it should be on the #2 rotor.....I can't say for sure, but it's a good idea to have the right.
Go check the wire colors going to the injectors. Note what colors are going to what injector. Then post it here. Then we will know if they are right or not.
Go check the wire colors going to the injectors. Note what colors are going to what injector. Then post it here. Then we will know if they are right or not.
#4
Junior Member
Thread Starter
Join Date: Apr 2003
Location: australia
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
sorry for the confusion i didnt have the primary and secondary swapped.
i didnt have the primarys injectors going to the correct rotars..ie on rotor 1 and rotor 2
the secondaries where the same.
and yeah i had the old girl on the dyno again but still had probs.
i later found the wastegate had a stuffed seal on the shaft.
so ill have to try again later
i didnt have the primarys injectors going to the correct rotars..ie on rotor 1 and rotor 2
the secondaries where the same.
and yeah i had the old girl on the dyno again but still had probs.
i later found the wastegate had a stuffed seal on the shaft.
so ill have to try again later
#7
Junior Member
Thread Starter
Join Date: Apr 2003
Location: australia
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
dale,
its a mtx8, thats what had me worried....maybe thats part of the power prob as well
ive double checked it know and fixed it...but ive had the loom of heaps of times and ive never looked which one went where...
so u can bet they were wrong?
its a mtx8, thats what had me worried....maybe thats part of the power prob as well
ive double checked it know and fixed it...but ive had the loom of heaps of times and ive never looked which one went where...
so u can bet they were wrong?
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM