Microtech can i remove it?
#1
Senior Member
Thread Starter
Join Date: Jul 2004
Location: kansas
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
can i remove it?
i would like to know can i remove the charcoal canister? (where do i wire those lines then?) , BAC valve ( again do i need to plug any holes?) and all the misc vaccuum device on the T/B.
thanks a lot
im goin microtech LT8s
thanks a lot
im goin microtech LT8s
#2
Microtech Tuning!
Join Date: Feb 2002
Location: 626 Socal
Posts: 1,828
Likes: 0
Received 0 Likes
on
0 Posts
Yes, but why would you want to?
Well actually, I did because it was in the way when I was removing the ABS pump.
One line comes from the vent at the oil-fill tube (or was it the vent at the block?). The other is to vent the fumes from the fuel pump. It doesn't really matter if you remove it or not.
BAC valve you can remove, and get a block-off plate.
Well actually, I did because it was in the way when I was removing the ABS pump.
One line comes from the vent at the oil-fill tube (or was it the vent at the block?). The other is to vent the fumes from the fuel pump. It doesn't really matter if you remove it or not.
BAC valve you can remove, and get a block-off plate.
Thread
Thread Starter
Forum
Replies
Last Post
Erosangel
3rd Generation Specific (1993-2002)
5
09-18-15 04:06 PM