Microtech Anyone WA that can help?!?
10-01-04, 12:51 AM
#1
Full Member
Thread Starter
Join Date: Aug 2003
Location: Auburn, Washington
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Anyone WA that can help?!?
Hi, I just wired in my LTX12, I have double and triple checked all the wires, and everything is correct but my car just wont start. I'm getting fuel and spark. And the car damn near starts. It sounds and feels like its firing up, but then it just wont go. I'm not sure if the timing is royally fucked up or not. But anyway, I dont know much about the microtech and tuning and setting everything up, and the manual I have doesn't really say much. So....Is there anyone in Western Washington that would be willing to help me try to get my car started? I'm fairly new to this forum and am in desperate need of some help!
10-21-04, 09:03 PM
#2
Junior Member
Join Date: May 2004
Location: New Zealand
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
similar problem
I just finished installing a LT10 and had the same problem. It would fire but not start.It turned out to be that I had the coils (for trailing/leadind) all messed up. I had both trailing on one rotor etc
10-21-04, 09:57 PM
#3
Full Member
Thread Starter
Join Date: Aug 2003
Location: Auburn, Washington
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Thanks. I have gotten the car started since i posted that. The problem ended up being that when i removed my CAS i forgot to mark exactly where the spindle was. So, my timing was horribly off and i just had to zero it out and everything. Thanks for the input though.