Megasquirt what to do after built v 3.0 board
Thread Starter
Joined: Apr 2005
Posts: 334
Likes: 2
From: south orange county
what to do after built v 3.0 board
well i am still confused on what to do as far as what to do to the board to make it setup for the rx. i know that i have to put in the three pull up resistors but what else. i cut off 2 opposing teeth on the cas and am justgoing to ust the built in vr circut. also how to wire it up to the car and what not. any help on wiring and board mods would be great help. o yea what about the pots?
Rotary Enthusiast
Joined: Oct 2001
Posts: 1,022
Likes: 4
From: Ontario, Canada
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM
