does anyone using the jbperf dual vrs board on a rx7 unmodified cas do the values on the resistors and caps have to be changes to make it on on a turbo2 cas.thanks

 

The FAQ sticky has the schematic(post #6, Third last pic) to use with the RX-7 CAS. You could compare it to the jb board schematic to see what's different. If you are using a V3.0 megasquirt board you only need to build the right side LM1815 circuit in both schematics (U2).

http://www.jbperf.com/dual_VR/dual_VR_v1_0_sch.JPG

Just a quick look, looks like you would need to change R10 to 82K ohm and C8 to .01 uf and jumper pin 2-3 on JP3 on the JP perf. board. Also there is no R7 in the FAQ schematic on the VR2 input circuit. I'm guessing you could just leave that out.

 

ook thanks