I have an MS 1v3.0 with zeal board installed running both vr conditioners on the zeal board because i wasn't sure if the one on the board was working. The harnes on the other hand is wired like Aaron cake says on his website. Is there something I would have to change in my harness??? if so why do I have rpm signal? Wiring and msq are both tuned and wired for the engine I'm trying my ms on

 

does it get spark if you turn the CAS by hand?

 

just tried spinning it by hand have spark in the trailing but not in the leading. i was spinning it at between 700-1300 rpm according to tuner studio

 

Odd, at lower RPM, the MS1 code only fires leading. Are you sure you wired the coil outputs correctly?

 

ill look over it today