I compiled these pin out data for my MS harness install, I just wanted a double check to ensure i have the right numbers. Also when installing the harness with A/C can i just jumper the pins on the ECU connector? 1E and 1F i believe?

 

Further, i am trying to make sure that my wiring harness layout is correct. I am using the error daughter card in a V 2.2 MS V 1. The daughter card is recieving both G+ and Ne+ and G-, Ne - and the following is how i am going to wire it up. If some one could look over this and tell me if there is anything wrong i would appreciate it. Also does pin 24 go anywhere now? i read some where else that it goes to the Ve- is that correct?



Any help greatly appreciated

 

looking at it now, i do not even know what the -ve is, anyone?