I am finally about to dive back into my rx7, and am doing a little research here.

is there any real advantages with going with say the newest ms equipment?

when i was doing research on squirting my fd a couple years ago the newest with ms 2 pcb 3.0 now there is ms1 pcb 3.57 and ms2 pcb 3.57

im just wondering if anyone could tell me what the difference would be between them, or if there would be any major advantages for shelling out the extra money for the new pcb.

thanks in advance
-bryan

 

the V3.0 board is functionally the same as the v3.57, but with components mounted through holes instead of surface mounted, which makes the V3.0 easier to modify

 

The v3.57 board has built-in pullup resistors and a second connector though, which makes it easier to use in an OEM-replacement setup.

Ken