Megasquirt OVERREV Spark Cut options ?maui?
#1
OVERREV Spark Cut options ?maui?
Hello
So I've been driving my 12A streetport nikki fed with a TII CAS and msns-extra controlling the ignition.
Um, I had a stretch of spirited driving a few weeks ago where it seems my motor saw 10500ish rpm.
I am greatly worried I've hurt it, and to prevent this happening again, I'm thinking of putting a Hardcut revlimit of 7600rpm.
If i just type 7600 or 8100 or whatever rev limit i want, will the controller simply stop the ignition events from happening until the revs drop below the setpoint?
This won't cause detonation? I know it might throw a hudge amount of fuel out the exhaust and destroy another set of hotdogs but I'd prefer this to cracking or spitting a side,corner or apex seal.
So I've been driving my 12A streetport nikki fed with a TII CAS and msns-extra controlling the ignition.
Um, I had a stretch of spirited driving a few weeks ago where it seems my motor saw 10500ish rpm.
I am greatly worried I've hurt it, and to prevent this happening again, I'm thinking of putting a Hardcut revlimit of 7600rpm.
If i just type 7600 or 8100 or whatever rev limit i want, will the controller simply stop the ignition events from happening until the revs drop below the setpoint?
This won't cause detonation? I know it might throw a hudge amount of fuel out the exhaust and destroy another set of hotdogs but I'd prefer this to cracking or spitting a side,corner or apex seal.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM