setup
MS2V3
zeal card
COP
fd/rx8 mode enabled


I have rpm at the ecu, I have spark but cannot get fuel.. I have verified fuel pressure 43# I have verified my injectors have 12v at the connector. I have gone through everything I can think of on the tune. I also opened up the ecu and the db37 to verify the wiring was intact.

I have posted an msq.

 

you say you have 12v, have you test that with a load or just a multi meter... sometimes a weak connection can give 12v but won't support any amps... you can use a tail light bulb to simulate a load.

 

its running now. rich as hell on a base tune but running

 

ok i verified the issue. i attempted to add launch control to the megasquirt this time around. when i deactivated it in tuner studio the car starts and runs. once activated i lose injector. got to figure out what i did wrong.

 

Always, always, start with the most basic of functionality on the ECU first for the initial tune, then turn on the fancy stuff one by one. I like to save a new version of the map every time I enable a feature, so I can go instantly back increase I did something stupid.

 

Yeah I accidentally saved over my previous running tune and there are big changes going na to turbo.