Megasquirt need to recal tps every time I start car
#1
Senior Member
Thread Starter
Join Date: Jun 2004
Location: Canada
Posts: 442
Likes: 0
Received 0 Likes
on
0 Posts
need to recal tps every time I start car
Has the tittle says. My guess is a ground issue but everything else seam bang on. I ground everything like the manual says but I might have missed something. Also can someone confirm the firing order. There is only two spot to place numbers. I have been running 1 2 in those spot. I was browsing aaron write up and notice his shows 1 3 in the firing order.
#2
MegaSquirt Mod
1 2 is the right answer for firing order.
Do you have the automatic recalibration for TPS turned on? That is known to be a bit buggy if you do, I'd suggest turning it off if you have that on.
What kind of TPS are you running?
Ken
Do you have the automatic recalibration for TPS turned on? That is known to be a bit buggy if you do, I'd suggest turning it off if you have that on.
What kind of TPS are you running?
Ken
#3
Senior Member
Thread Starter
Join Date: Jun 2004
Location: Canada
Posts: 442
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for correcting firing order. I seen it on arron write up and was concerned. I am using fd tps. I was unaware of the auto tps thing. I will check it out.
#4
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Made a note to correct the firing order in my MSQ and writeup. That's just as it is displayed in TunerStudio though, not how the engine is fired. So it's aesthetic and won't effect how the engine runs. I was simply lazy in not changing it from the defaults.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM