looking at building a cheap setup for a injected 13bbp .i already own a ms3 with ms3x and knock module and egt amp for my turbo setup so not entirely noob on this but all my research was for a serious turbo setup with most things running off the ms3x.

so can the ms3 on its own run 4 inj sequential?or is it banked?i know it will still do staged
and what ignitors are people using for bosch HEC715s in cop configuration?have 4 of these coils left over from a old 13bt microtech setup and went with aem coils for the turbo setup.

cheers

 

MS3 without the ms3x will only have 2 injector outputs.

As far as igniters, the BIP373's have treated me well so far.

 

so they just fire off as a pairs on each output?can still be staged correct
can the ms3 fire sequential ignition?or just in wasted spark?

cheers

 

An MS3 is basically just an MS2 with a better processor and an SD slot. The hardware on the board is the same. Ignition control will take (slight) modification to the board. Injectors can be staged as INJ A would be primaries and INJ B would be secondaries.