Megasquirt Lost E-Fan after upgrade to MS2
#1
Lost E-Fan after upgrade to MS2
This is driving me nuts.
E-fan output was working fine on MS1. Just upgraded to a MS2 board, car fires up and runs(ish, obviously needs tuning) but my E-fan doesn't ever turn on. Luckily I caught it just as the engine was approaching 200 degrees
Even in output test mode, turning on/off IAC1 does nothing.
Everything was built & configured according to Aaron's write-up.
Is there anything obvious I could be missing before I dive into more details?
E-fan output was working fine on MS1. Just upgraded to a MS2 board, car fires up and runs(ish, obviously needs tuning) but my E-fan doesn't ever turn on. Luckily I caught it just as the engine was approaching 200 degrees
Even in output test mode, turning on/off IAC1 does nothing.
Everything was built & configured according to Aaron's write-up.
Is there anything obvious I could be missing before I dive into more details?
Thread
Thread Starter
Forum
Replies
Last Post
Slash200
Power FC Forum
0
04-04-16 06:23 AM