Hey,

So I have my launch control circuit all setup and i have the wire that would recieve the signal from my clutch switch running to spr4.

My question is, do i have to run a jumper from spr4 to a pin on the db37, or are the spares already running to a pin on the db37?

 

The spares just go from the hole on the board to the pin in the DB37. From the hole in the board, you need a seperate wire (and maybe conditioning, depending on the circuit) to connect spr4 or any other spare pin to the appropriate JPx pin.

 

Yes, my question is which pin on the DB37 does SPR4 associate with?

 

I don't remember which one goes where off the top of my head, but it's really easy to figure out using a multitester... Just put it in continuity mode, and touch one side to the hole, and touch the other side to each pin until you get continuity...

Ken

 

Ok, thanks

 

Should be pin 6.