Megasquirt Innovate LM-1 to MS2?
Thread Starter
Banned. I got OWNED!!!
iTrader: (2)
Joined: Oct 2004
Posts: 6,122
Likes: 1
From: London, Ontario
Innovate LM-1 to MS2?
Anyone know exactly how to hook this up properly? Do i need something inbetween the Wideband to the MS to convert the signal properly? THanks in advance
Thread Starter
Banned. I got OWNED!!!
iTrader: (2)
Joined: Oct 2004
Posts: 6,122
Likes: 1
From: London, Ontario
NVM ... found my own answer at DIY:
"First you’ll want to configure your analog output for 10-20:1 AFR from 0-5v using the Innovate 'LM Programmer' software (part of the LogWorks package).
Then you’ll do the same for your MegaSquirt:
First in the MegaTune Configurator you need to select Innovate 10-20:1 0-5v
Then in the MegaTune EGO settings select 'wideband sensor'.
Lastly (and only for MS-II users, MS-I can skip this) you’ll want to go to TOOLS>Calibrate AFR Table and choose the Innovate 10-20:1 0-5v setting and click OK, this will calibrate the MS to read the LC-1 properly."
Then you’ll do the same for your MegaSquirt:
First in the MegaTune Configurator you need to select Innovate 10-20:1 0-5v
Then in the MegaTune EGO settings select 'wideband sensor'.
Lastly (and only for MS-II users, MS-I can skip this) you’ll want to go to TOOLS>Calibrate AFR Table and choose the Innovate 10-20:1 0-5v setting and click OK, this will calibrate the MS to read the LC-1 properly."
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
Sep 30, 2015 08:13 PM
