Megasquirt Ignition Options settings when Fuel Only?
04-21-18, 07:02 PM
#1
Ignition Options settings when Fuel Only?
Running Microsquirt on 12A, OEM igniton want to start with Fuel Only first.
Want to know how to set the Ignition Options table
In Ignition Options, Spark Mode I select "Fuel Only". But what about Skip Pulses, Ignition Input Capture, Number of Coils, Cam Input, and Flip Polarity On Cam?
I have connected to negative side of the Leading coil to trigger Microsquirt. Do I need a resistor inline on this trigger wire?
Initially the engine started twice briefly and now won't start. For those starts it had an RPM signal but now doesn't get a RPM signal
Want to know how to set the Ignition Options table
In Ignition Options, Spark Mode I select "Fuel Only". But what about Skip Pulses, Ignition Input Capture, Number of Coils, Cam Input, and Flip Polarity On Cam?
I have connected to negative side of the Leading coil to trigger Microsquirt. Do I need a resistor inline on this trigger wire?
Initially the engine started twice briefly and now won't start. For those starts it had an RPM signal but now doesn't get a RPM signal
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Adaptronic Engine Mgmt - AUS
21
11-17-19 08:22 PM
RotaryEvolution
Single Turbo RX-7's
17
01-20-16 02:33 AM
innertwist
1st Gen Archive
12
07-22-07 02:40 PM