So I am finally nearing the end of my very slow MS2 install and am ready to wire in the fuel pump. Long ago I did the fuel pump rewire.

Now following Aaron Cake's MS guide all I need is the relay up by the ECU, and the 12V and ground wires running back to the pump, correct? I can just get rid of the resistor and other relay and wiring from the engine bay back (keeping the fuel level sender wiring of course)? I just want to be 100% sure before I clean out the old wiring and potentially screw something up.

 

Yea, you can get rid of the resistor pack, since there isn't anything in MS that would switch pump flows under certain conditions.

 

Perfect, just what I needed to know. Thanks!