So when you set this

you set the outputs

as

Spark A
Spark B
and Spark C

Which LEDs are which outputs?

I'm not using FD coils I'm using 4 external ignitors and 4 seperate coils

 

And how do i interpret the LEDs as which modules to send the signals to?

I looked in the schematics

Theyare called accell etc but they don't show you what pins to use

 

The LED closest to the serial port is leading... the middle is rear rotor, the last LED is front rotor.

 

MUYTHAIBXR This is what I was talking about doing on the msnse website, except I would like to fire the coils with vb921's for dwell control. I would like to use one wasted spark MSD coil for leading and to single coils for trailing. The most accurate and powerful igntion hardware for the rotary would be these coils at acost of less than $120 total.
I also spent $150 for an Electromotive 60-2 crank wheel and vr sensor. For a price of $370 to eliminate the CAS and huge factory coils . And create a hell of an accurate and powerful igniton system. The only piece I am missing is the software to support spark output inverted. If it was developed for ms1 or ms2 it would be great. I don't have a problem buying the ms2 when your new software is available.

 

Testing my signature