Ok i have FD wire harness Fuel Rails Injectors 550 and 850 upper manifold with tps and temp sensors and fd throttle body. The fuel rails will be sitting in a custom carbon fiber manifold to connect it to my 12a 4 port. question is on the megasquirt rx7 faq it says that i need to change the bias resistors in r4 on the board and that the fd is "probably the same" does anyone know if i can replace the same resistors to use the stock fd sensors. planning to build a v3 board.
thanks for your time

 

A check of the specs on the FD sensor will tell you. If it's temp/resistance characteristics match the earlier models, you can follow the directions directly. If not, you'll need to follow the general instructions at megasquirt.info. Either way you should be able to use the existing sensors.