Megasquirt communication problem
Thread Starter
Junior Member
Joined: May 2009
Posts: 7
Likes: 0
From: Conifer CO
communication problem
Just got the new ECU w/PCB3.0 using Firmware MS2-extra 2.1.0.
It took an hour of plugging and unplugging everything to finally get it to communicate with Megatune. Now I can't get it to communicate again. I'm using the jim stim plugged into a 110 transformer set at 9 volts, using the DYIautotune serial to usb converter.
The "PMP" light is the only light on, on the stim and all 3 lights are on, on the ECU. Some times when I plug the stim in the "PMP" and "IG" lights are on. Turning the dials on the stim doesn't change the lights.
When I take the v3.0 ECU 2.687 out of the other racecar and plug it in, everything works fine and it links up right away.
Help.
It took an hour of plugging and unplugging everything to finally get it to communicate with Megatune. Now I can't get it to communicate again. I'm using the jim stim plugged into a 110 transformer set at 9 volts, using the DYIautotune serial to usb converter.
The "PMP" light is the only light on, on the stim and all 3 lights are on, on the ECU. Some times when I plug the stim in the "PMP" and "IG" lights are on. Turning the dials on the stim doesn't change the lights.
When I take the v3.0 ECU 2.687 out of the other racecar and plug it in, everything works fine and it links up right away.
Help.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM