I have my bac on my tii on the uim. But my main question is what i have to do to the bac to make it work as of right now i have the bottom port blocked do i have to have that open or no. Im pretty sure the bord is set up ro run the stock bac. I bought it an went threw an everything checked out to run the stock bac.

 

You need to take off the vacuum cap, connect +12v to one pin on the BAC, and the other to the circuit on the v3 board (assuming it is set up for the BAC).

Ken

 

And make sure to run that uncapped port to a source of filtered air.

 

im running the 2.2v board with the stuff to do it me an aaron talked about it a few weeks ago he said i can do it but its a pain to get it right. But aaron by filtered source like put a little filter on it like a breather or to my air filter. right

 

You can just stick a breather filter on it, but then you have to put up with the massive sucking sounds the valve will create in operation. So I'd suggest running a tube to your TID/air filter.

 

ok im going out side now to work on it. Ill give it a shot for now im just going to put a breather on it cause im not really driving it very much. Cause im trying to clean everything up under the hood. But thank you aaron N ken.