I plan on reusing my CAS wire since its already run through the loom and such.... Now I believe I need to move a few jumpers and wires on the board but I cannot remember which ones. Is this correct? Do any of those resistors and jumpers move back once the VR circuits are taken out? I plan on removing the zeal daughterboard as I used that for my second VR circuit.

My plan is to trace the current wires so I know which ones are inputs to the ECU from the CAS, Then move one of those wires to the the Hall effect input location.

For those who have upgraded to the FFE kit, please provide assistance!!

 

Doesn't that kit use a VR sensor?

 

The cheaper version uses a VR sensor, the expensive version uses a hall effect sensor. I chose the hall effect for a more consistent and better reading.