Megasquirt 2nd trigger zero crossing help
#1
Junior Member
Thread Starter
Join Date: Dec 2006
Location: OZ
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
2nd trigger zero crossing help
Hi guys,
just finished modding my 2nd trigger to zero crossing mode by grounding pin 14. When I put the multimeter on both 5v and ground with the lm chip removed I get 0.8K ohm resistance is that right? Or do I have a leak somewhere?
Just want to check before I blow something up.
Thanks
Jono
just finished modding my 2nd trigger to zero crossing mode by grounding pin 14. When I put the multimeter on both 5v and ground with the lm chip removed I get 0.8K ohm resistance is that right? Or do I have a leak somewhere?
Just want to check before I blow something up.
Thanks
Jono
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Are you measuring in circuit? As in, is the 2nd trigger circuit installed on the Megasquirt board? If so, you are measuring across the entire Megasquirt circuit...
#3
Junior Member
Thread Starter
Join Date: Dec 2006
Location: OZ
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Yeah i'm measuring the whole circuit. I just measured from the 5V and Gnd points on proto area. Whoops I can see my silly mistake.
Cheers and hope the circuit works!
Cheers and hope the circuit works!