1993 LHD Red RX-7 - Base Model
For Sale1993 Mazda RX-7
-
Price
$20,000• OBO
- Location Lebanon, OH, 45036, USA
- Condition Used
- VIN JM1FD3317P0204082
- Trim Base
- Transmission Manual
- Exterior Color Red
Description:
93 base model LHD - red exterior / black interior ~98k miles
- all stock except Racing Beat intake/intercooler separator (don't remember what it was exactly called) and radio
- when I purchased it, Carfax came back clean and the Mazda service records showed all recalls were completed
Issues-
- did run okay but has been sitting for past 5 years (life happens) and because it developed a fuel leak near intake manifold
-Upper intake manifold was taken off to get to fuel dampener (what I believe to be cause of leak - have part) but never finished
- Tried to fix odometer not lighting up was working then tach would occasionally bounce around/not work (in odometer thread)
- ignition coils bad but have used part to replace
- has not had compression test but ran okay before fuel leak
- does have 5th gear synchro issue
- replaced aftermarket fuel pump that was not good with new OE before fuel leak
- a/c does not work but all components still installed
Parts
- comes with some new factory parts and some used parts
- new OE cluster hood, front windshield cowl, b-pillars, cargo cover, front headlight covers
- used additional dash, bubble tech map lid and passenger door handle, spare e-brake handle, 99 spec taillights (still have originals)
- rotary compression tester tool
Exterior
was repainted red at some point and there is overspray in areas
small bit of rust on passenger side rear hatch corner
Interior
cluster hood needs replaced (shattered when getting odometer out) but have new OE part
cloth seats show wear
shifter and e-brake handle show wear
missing map lid (bubble-tech part on hand)
Pictures to follow.
Here are the pictures. The reason the driver rear panel is out was because I was changing the hatch strut. So one side was done but not the other. I didn't take a picture of the radio antenna up but it does still work. Some original pieces like the original map lid I kept even though they were broke or not in great shape was so I could either make a mold and remake them or better now just scan them and 3D print in what ever material and/or color. So those pieces are there.
BubbleTech map lid
BubbleTech map lid
BubbleTech passenger door handle
BubbleTech passenger door handle
BubbleTech center foam support
BubbleTech center foam support
AST tank, original in car but it looked and seemed newer
AST tank, original in car but it looked and seemed newer
used coil pack to replace cracked original
Last edited by v1point0; Jan 31, 2025 at 02:06 PM. Reason: Specifiy whether parting out or not
Small dent on passenger side
Fuel door does work from the lever by drivers seat
Scratch from folks fixing my old house
Bottom window trim is inside car. Have new clips and parts to make trim work better.
Rear hatch glass defog lines are scrapped. Someone in previous life took off the tint on the windows and ended up damaging the lines.
Trending Topics
Cheap fuel filter. I did replace once after I got it with a genuine mazda filter.
used e-brake handle that is in a little better shape than original
new
original part
original part
small hole drilled, was there when I got it
