rotary noob
#1
Junior Member
Thread Starter
Join Date: Apr 2011
Location: New Jersey
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
rotary noob
Whats up rx7 club, my name is chris and im new to the whole rotary scene. i recently baught a 91 turbo 2 and its allll new to me. it needs a little love and i have no idea where to shop around for rx7 parts at all.. any good sites?
#3
Junior Member
#6
Junior Member
Thread Starter
Join Date: Apr 2011
Location: New Jersey
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
thanks a lot guys ill check into it.. also i made a thread asking about injectors.. 43 views... no replies.. if you guys get a minute check it out, i would love some help... just got the car into my garage tonight.. plan on working on it tomorrow.
Trending Topics
#9
Junior Member
Thread Starter
Join Date: Apr 2011
Location: New Jersey
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Central... Hillsborough.. idk if u ever heard of it but its nice to kno someone is local who may be help . i just pulled the intake manifold off today and got the injectors out. they are reading 14ohms. i kno thats in spec, but im not sure of the spray pattern. the kid i baught the car from said it needed one and all of them seem to ok as far as the resistance check goes. im ordering some tonight anyway cuz the insulators are cracked and breaking and they are really rusty.. the gastket on the manifold seems to be in perfect condition, doesnt look like the car was eve run since its been on... i baught it hoping for a daily but its turning into a project... ANY ADVICE? id love some! when i get the injectors im putting them on and draining the gas tank and putting fresh gas in and im also doing a coolant flush... and im going to HOPE it runs fine after all that.. also i was reading that the injectors have to be angled a special way?? any advice in doing that as well?
Thanks again for looking all!!! much appreciated.
Thanks again for looking all!!! much appreciated.
#12
Junior Member
Thread Starter
Join Date: Apr 2011
Location: New Jersey
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
convenient. i go to school in union (lincoln tech), also i am looking for the intake manifold gasket between the 2 manifold and i cant find it anywhere but mazdatrix. everytime i press checkout it empties my cart and tells me there is nothing in it to cehckout.. any other sites? i cannot find it anywhere!! the only ones they have is for between the manifold and engine.
#13
Full Member
Join Date: Sep 2008
Location: carteret nj
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
cool i graduate from there back in 07 try atkins site i usually get it from them
convenient. i go to school in union (lincoln tech), also i am looking for the intake manifold gasket between the 2 manifold and i cant find it anywhere but mazdatrix. everytime i press checkout it empties my cart and tells me there is nothing in it to cehckout.. any other sites? i cannot find it anywhere!! the only ones they have is for between the manifold and engine.
Thread
Thread Starter
Forum
Replies
Last Post
datfast1
Old School and Other Rotary
18
06-20-19 10:53 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM