Hey everyone - Wolf3d software project
02-08-09, 12:52 AM
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Feb 2009
Location: Western Australia
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Hey everyone - Wolf3d software project
Hey all,
I just registered on this forum because of the Wolf3d software project thread:
https://www.rx7club.com/wolf-3d-125/wolf3d-software-project-774332/#post8429704
only to find that I couldn't contact hwnd the author or reply to that thread until I had 5 posts...
I'm very interested in reverse engineering / modifying the wolf3d v4 software, as my project car running a wolf3d v4 ecu is nearing completion.
Car is an ae85 toyota sprinter trueno with a 3sgte from a toyota mr2.
I have a degree in computer science + engineering ... might be able to put it to good use
Does anyone have any update / code I could look at? or could someone pm hwnd for me as I don't have enough posts and don't really want to post useless stuff just to get the count up?
Cheers,
Jeremy
I just registered on this forum because of the Wolf3d software project thread:
https://www.rx7club.com/wolf-3d-125/wolf3d-software-project-774332/#post8429704
only to find that I couldn't contact hwnd the author or reply to that thread until I had 5 posts...
I'm very interested in reverse engineering / modifying the wolf3d v4 software, as my project car running a wolf3d v4 ecu is nearing completion.
Car is an ae85 toyota sprinter trueno with a 3sgte from a toyota mr2.
I have a degree in computer science + engineering ... might be able to put it to good use
Does anyone have any update / code I could look at? or could someone pm hwnd for me as I don't have enough posts and don't really want to post useless stuff just to get the count up?
Cheers,
Jeremy
03-15-09, 01:22 PM
#2
Hey all,
I just registered on this forum because of the Wolf3d software project thread:
https://www.rx7club.com/showthread.php?p=8429704
only to find that I couldn't contact hwnd the author or reply to that thread until I had 5 posts...
I'm very interested in reverse engineering / modifying the wolf3d v4 software, as my project car running a wolf3d v4 ecu is nearing completion.
Car is an ae85 toyota sprinter trueno with a 3sgte from a toyota mr2.
I have a degree in computer science + engineering ... might be able to put it to good use
Does anyone have any update / code I could look at? or could someone pm hwnd for me as I don't have enough posts and don't really want to post useless stuff just to get the count up?
Cheers,
Jeremy
I just registered on this forum because of the Wolf3d software project thread:
https://www.rx7club.com/showthread.php?p=8429704
only to find that I couldn't contact hwnd the author or reply to that thread until I had 5 posts...
I'm very interested in reverse engineering / modifying the wolf3d v4 software, as my project car running a wolf3d v4 ecu is nearing completion.
Car is an ae85 toyota sprinter trueno with a 3sgte from a toyota mr2.
I have a degree in computer science + engineering ... might be able to put it to good use
Does anyone have any update / code I could look at? or could someone pm hwnd for me as I don't have enough posts and don't really want to post useless stuff just to get the count up?
Cheers,
Jeremy
eh, its dead. the firmware was the big issue as i recall BUT with the software, you can do a few things software / tune wise but not change / add features - thats firmware level.
Thread
Thread Starter
Forum
Replies
Last Post
