Would these seats fit the car (FD)?
#1
Senior Member
Thread Starter
Join Date: Jul 2002
Location: Quincy MA
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
would these seats fit the car..
i was wondering if the seats that has the measurement of 50x27x18 in inches would that fit into the FD? if not what would be the max measurement that fits?
#4
Mr. Links
iTrader: (1)
Take a look at this measurement chart for the Sparco seats:
http://www.sparcousa.com/resourceFiles/26.pdf
Use the Torino as a guide. If the seats you are looking at are about the same size, then you should be able to shoehorn them into the FD.
Keep in mind that there are only a few seat makers that also have rails for the FD. Most likely, you'll have to make adapter plates for the stock rails.
http://www.sparcousa.com/resourceFiles/26.pdf
Use the Torino as a guide. If the seats you are looking at are about the same size, then you should be able to shoehorn them into the FD.
Keep in mind that there are only a few seat makers that also have rails for the FD. Most likely, you'll have to make adapter plates for the stock rails.
#5
Senior Member
Thread Starter
Join Date: Jul 2002
Location: Quincy MA
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
so the seat measurement is 50x27x18.. so does it go by 50 as the height, 27 as the shoulder width and 18 as the seat width?.. because thats the measurement of the seat that guy told me .. if its 27 shoulder then its too width right?
#6
Senior Member
Thread Starter
Join Date: Jul 2002
Location: Quincy MA
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
thanks.. for that info.. i think i'll have to pass on these seats.. cause the measurement seems not to fit
Last edited by silylanjie; 08-22-05 at 04:56 PM.
Thread
Thread Starter
Forum
Replies
Last Post