who makes this lip?
Thread Starter
Junior Member
Joined: Jun 2004
Posts: 11
Likes: 0
From: Houston, TX
who makes this lip?
i found this while looking around yahoo japan auctions
if someone here can translate what the text says, that might help
http://page4.auctions.yahoo.co.jp/jp/auction/d48479485
if someone here can translate what the text says, that might help
http://page4.auctions.yahoo.co.jp/jp/auction/d48479485
http://world.altavista.com/ Is your best friend!!
(but i still have no idea what any of that means)
Auction automobile, motorcycle part wrapping and the new item for aero Matsuda! ! RX? Carbon front lip for 7FC3S latter term
New item! ! RX? It is the carbon front lip for the 7FC3S latter term. The carbon has used the wet carbon. Being to use the carbon of setting, there is no either eye deterioration. As for the surface being to be gel coat S clear of the national pigment make, you think that there is a gloss which until now is not. As for resin the Hitachi polyester resin NR5910PT? It was superior in durability M and ester - by mixing the P290K unsaturated polyester resin, it could hold down the distortion which is the weak point of the wet carbon to minimum. In the edge there is a connection of the carbon. The instruction manual and bis etc. of installation being not to have been attached, we recommend that you install with the shop and the like.
(but i still have no idea what any of that means)
Auction automobile, motorcycle part wrapping and the new item for aero Matsuda! ! RX? Carbon front lip for 7FC3S latter term
New item! ! RX? It is the carbon front lip for the 7FC3S latter term. The carbon has used the wet carbon. Being to use the carbon of setting, there is no either eye deterioration. As for the surface being to be gel coat S clear of the national pigment make, you think that there is a gloss which until now is not. As for resin the Hitachi polyester resin NR5910PT? It was superior in durability M and ester - by mixing the P290K unsaturated polyester resin, it could hold down the distortion which is the weak point of the wet carbon to minimum. In the edge there is a connection of the carbon. The instruction manual and bis etc. of installation being not to have been attached, we recommend that you install with the shop and the like.
Thread
Thread Starter
Forum
Replies
Last Post