I have seen a lot of photos of cars with the EFINI badges on them. I like the look. I see several vendors sell them, my question is, how do you remove the old 'toilet bowl" badge without damaging the paint?

What do you use to "paste" the new ones on?

 

Front emblem has two pincer bolts holding it down..if you have small enough hands you can reach underneath and pry them off.

Back emblem is stuck on there with two sided tape...use dental floss.

I attached the front efini emblem with the two pincer bolts and two sided 3M tape. 3M tape for the rear. Be sure to clean the surface thoroughly.

Should take about 15 minutes.

 

use a hair dryer, heat them up a bit then rip it out or use dental floss

 

none of that waxed mint crap tho, Rx-7s are picky about flavors Naw, but the unwaxed wont rip as easy, i just put the new mazda logos on today.

 

hrm...i don't like this thread... i've had badges stolen off my cars and friends cars too often
=(

 

ok so use regular dental floss for the black mazda badge thats on the back but how do u take off the thin stickers on the back and sides?

 

I have the thin white MAZDA on the front bumper, what is the best way to remove the sticker without ruining the paint?

 

im not sure about those stickers, they didnt come on the newer 7s so i dont know what to tell u.

 

I took some dealer sticker off my 87T2 today with some bumper sticker remover, (one whole can) avail from Autozone, and a razor blade. The paint was not harmed. However you gotta be really careful with the razor. I mean do it slowly or you will surely screw it up.

It worked for me. BTW the sticker had been on there since 87.

 

how many badges are there? The toilet bowl and the enfini? Are those the only 2?

 

yeah

 

theres the flying "m" one also. Or are u referring to the ones that came on the car? im lost....lol