need a new nose (for the car, you goof)
#1
Full Member
Thread Starter
Join Date: Oct 2002
Location: Clermont, GA
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
need a new nose (for the car, you goof)
I'm looking for a fiberglass nose that uses the stock 93 signal lights and looks stock, but where the side and center air inlets extend a lot lower and where the bottom lip ends very close to the ground for a splitter. any suggestions before I make my own?
Tom
Tom
#2
Rotary Freak
iTrader: (1)
Re: need a new nose (for the car, you goof)
Originally posted by tom jelly
I'm looking for a fiberglass nose that uses the stock 93 signal lights and looks stock, but where the side and center air inlets extend a lot lower and where the bottom lip ends very close to the ground for a splitter. any suggestions before I make my own?
Tom
I'm looking for a fiberglass nose that uses the stock 93 signal lights and looks stock, but where the side and center air inlets extend a lot lower and where the bottom lip ends very close to the ground for a splitter. any suggestions before I make my own?
Tom
Ruled out the f/glass b/c everyone of them had cracks even if not daily driven.
A 99 didn't fit well at all with the stock oil cooler plus the price ($1.5K) was too much as I was also doing a repaint.
The stock 93 nose was $400 from Malloy. I went with this. No problem with insufficient air when I installed the Fluidyne. Have not seen above 195F yet whereas in winter I used to see 210F in traffic with stock rad.
Thread
Thread Starter
Forum
Replies
Last Post
fastrx7man
3rd Generation Specific (1993-2002)
33
09-02-15 09:42 PM
smikels
2nd Generation Specific (1986-1992)
3
08-18-15 01:26 PM