I was wondering if anyone could direct me to a write-up or just give me some advice on the install of Shine (feed style) rear fenders. My main question is do you need to cut the stock quarter panel like you do with wider rear fender options...



Any advice would be much appreciated

Thanks in advance

 

PM imstillonjava or purerx7. Both have Feed kits and most likely have your answer

 

Yes, you need to cut the stock rear 1/4 panel, it really doesn't matter how shitty of a job you do as the feed fender will cover it. Here are mind molded:



note that I do have black lugnuts now.

 

Thanks for the info, The car looks great.

 

Just like first picture cut and lift them up and cut them out completly, better for fitment" First use fiber, sand them nice, than use bond make the body it self look nice [ just like pure said it dosen't really matter under panals because it wont show also if u mold it dosen't matter but if u want race look with revits than first tape them drill holes put two revits so it keeps from moving around than u adjust drill them back out must paint them seperatly or else your going to have hard time with little gab that paint is covering but in times it will be first place to have paint chip.
also revits are 3/16 or 25, most shops have revit gun so u'll be fine.