Free Rear speaker bracket template
#26
Full Member
iTrader: (1)
Also, here's a version that prints onto two 8.5" x 11" pages. If you can't print 11" x 17" give this a try. You'll need to trim the 1/4" border off each page (most home printers can't print to the edge of the page, so I gave it a 1/4" border), then tape the two pages together. I guess you could also just fold the border under instead of trimming; whatever gives you the straightest edge!
The following users liked this post:
ImamurA (12-12-22)
#27
Has anyone found/made dimensions compatible with 3d printing yet? Or even a template with measurements for cutting out of sheet metal etc?
that paper one doesn't seem to have any measurements.
that paper one doesn't seem to have any measurements.
#29
That would be awesome...my buddy does 3d printing,,,or even aluminum if I got the measurements...angles to bend are further back in the post I saw.
width of the metal would be great, not just length of the arms and all...
width of the metal would be great, not just length of the arms and all...
The following users liked this post:
ImamurA (12-12-22)
The following users liked this post:
cnidus (09-20-21)
Thread
Thread Starter
Forum
Replies
Last Post