Car Alarm install question
#3
TIMEATK
Join Date: Jun 2001
Location: Silicon Valley, Ca.
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by unvmyrx7
door lock actuator
door lock actuator
Since the FD doesn't have "centralized" door locks there needs to be an actuator to move the driver side lock so that it will automatically lock both doors. Just make sure not to forget the ground out the STOCK security DISARM wire. That way when you unarm your alarm the the stock alarm doesn't go "WTF!!!!" and go off on you.
#5
Where in rx7 circuitry to you install?
I was hooking up my alarm and I could fine the wires to plug into the actuator for the alarm to control. Do you guys know which wires they are?
Thanks
Thanks
#6
Originally posted by Magilla
In Australia, you must put an immobiliser on your car as soon as you buy it (if there isn't one already) and you must be licenced to install it...
In Australia, you must put an immobiliser on your car as soon as you buy it (if there isn't one already) and you must be licenced to install it...
But its going on a FB so i dont have to worry about stock alarms
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM