Anyone removed the orange in the new 93spec lights?
#1
Ozone Depleter
Thread Starter
Join Date: Jul 2002
Location: StL
Posts: 1,610
Likes: 0
Received 0 Likes
on
0 Posts
Anyone removed the orange in the new 93spec lights?
hey every1,
I dont like the orange in the new black/smoke turn lights i got, and i assumed it was j/ a orang bulb, so i went out and got some of those blue sylvania bulbs that light up orange...put them in and realized there was a orange insert Has anybody cracked these lights open to remove it yet? plmk
-Zach
I dont like the orange in the new black/smoke turn lights i got, and i assumed it was j/ a orang bulb, so i went out and got some of those blue sylvania bulbs that light up orange...put them in and realized there was a orange insert Has anybody cracked these lights open to remove it yet? plmk
-Zach
#4
Tony Stewart Killer.
iTrader: (12)
I have paid to have 3 sets of tail lights done the last couple of years didnt want to mess that up. I was talking about the front combo lights I did. The way I did it was take out the screws in the lense (dont think yours have that
then I put it in a glass tray in the oven for about 3 minutes and with gloves would take them out and try to pry them open every minute. When I felt the glue was hot enough for me to take off the entire lense then I did it slowly. Just keep checking them every minute or so after the first 2-3 minutes in there. then make sure to seal them again with some glue or rtv but dont get any on the lense or you are FU**ed. I did that once and tried to clean the lenses and anything I used made the lense dull
If I were you id leave it how it is honestly. It might not look good as I found out. If you really want to do it wait for someone else to try it first
then I put it in a glass tray in the oven for about 3 minutes and with gloves would take them out and try to pry them open every minute. When I felt the glue was hot enough for me to take off the entire lense then I did it slowly. Just keep checking them every minute or so after the first 2-3 minutes in there. then make sure to seal them again with some glue or rtv but dont get any on the lense or you are FU**ed. I did that once and tried to clean the lenses and anything I used made the lense dull
If I were you id leave it how it is honestly. It might not look good as I found out. If you really want to do it wait for someone else to try it first
#5
Ozone Depleter
Thread Starter
Join Date: Jul 2002
Location: StL
Posts: 1,610
Likes: 0
Received 0 Likes
on
0 Posts
yeah i did the oven trick for my taillights to 99spec them, but when i tried to re-heat them and re-assemble them in the oven, the heat melted the outside part and creased it used a heatgun and it was fine lol. I guess ill give it a shot sometime and see how it works out. Id just like to get rid of the orange and have j/ smoked lenses to totally clean up the front end.
-Zach
-Zach
#6
-
iTrader: (3)
Join Date: Nov 2002
Location: SF Bay Area
Posts: 624
Likes: 0
Received 0 Likes
on
0 Posts
if these new lights are like a lot of aftermarket lights then you cant open them up. the stock lights are polycarbonate with that soft glue to hold them on, a lot of aftermarket lights i have seen are pmma lenses and they have a very hard glue that doesnt soften. you will break the lens trying to get it off.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM